How to perform authorization of the Yanhua Mini ACDP module

This article will guide you on how to authorize the Yanhua Mini ACDP module automatically.

Here are the steps:

The new module has an authorization code sticker on the outside.

Please peel off the green protective film.

If the authorization code is covered with residual gel, remove it with an eraser.

Make sure the QR code is clearly visible.

Open the ACDP APP and check that the ACDP device is connected correctly.

Click "Me" in the lower right corner and choose "Module List".

Click "Add" in the lower left corner, then click "Scan QR Code" to continue.

The authorization card number will be filled in automatically.

You can also manually enter the authorization card number.

Please note that letters must be capitalized.

Check the authorization card number, make sure it is correct and click "Submit".

The authorization is successful!

Video guide:

Ford DPS6/MPS6 Gearbox Clone with Yanhua Mini ACDP

This is a tutorial on how to clone Ford DPS6 & MPS6 gearbox module with Yanhua Mini ACDP step by step. The MPS6 gearbox clone procedure also applies to Volvo, Land Rover, Chrysler, Dodge, etc.

How to Clone Ford DPS6 Gearbox?

Tip: Click "Help" to view the connection diagram before operation.

Accessories Required:

Ford DPS6 gearbox module

20PIN cable

OBP+ICP adapter

ACDP host

Module 26 Ford DPS6 interface board

Connection

1. Install the interface board.

2. Short the jumper cap on the OBP+ICP adapter to the "CAN-R" JOIN side.

3. Connect to ACDP together

Operation

Step1. Backup Original Data

Mini ACDP >> Ford >> Gearbox clone >> DPS6 >> Connect >> OK

Please ensure a stable network connection.

DO NOT pull out the device during working.

Click "Continue".

Check system info,

Continue >> OK >> OK >> OK

Read/write data >> Full backup data >> OK >> Continue

Save chip data.

Reading chip data finished.

Return back to the previous page.

Disconnect >> OK >> Continue

Disconnect finished.

Step2. Write to New Gearbox

Connect the new DPS6 gearbox module & prepare to write the original data.

Connect >> OK >> Continue >> Continue >> OK

Connect system finished.

Read/write data >> Full write data >> OK >> Continue >> Load original data file

Ready to write chip data, please don't cut the power nor pull out the device during the programming!

Click "Continue".

Writing chip data finished.

Return back to the previous page.

Disconnect >> OK >> Continue

Disconnect finished.

Completed!

How to Clone MPS6 Gearbox?

Tip: Click "Help" to view the connection diagram before operation.

Accessories Required:

MPS6 module

OBP+ICP adapter

ACDP host

20PIN cable

Module 14 MPS6 interface board 

Connection

1. Install the MPS6 interface board.

2. Short circuit the CAN resistor on the OBD+ICP adapter to the "CAN-R" JOIN side.

3. Connect ACDP, OBP+ICP adapter & MPS6 gearbox.

Operation

Step1. Backup Data

Mini ACDP >> Jaguar/Land Rover >> Gearbox clone >> Freelander >> MPS6 >> Full backup data >> Continue

Remember to save module info, click "Continue".

Save chip data file.

Backup chip data finished.

Step2. Write Data

Connect the new MPS6 gearbox & prepare to write the original data.

Full write data >> Continue >> Continue >> Load chip data file

Ready to write chip data, please don't cut the power nor pull out the device during the programming!

Writing chip data finished.

Completed.

http://blog.obd2shop.co.uk/ford-dps6-mps6-gearbox-clone-with-yanhua-mini-acdp/