This post will guide you on how to use Yanhua Mini ACDP and ACDP Module 11 to do BMW E chassis 8HP EGS ISN refresh.
Check all the accessories we need:
ACDP main unit
OBP ICP adapter
8HP interface board
20Pin cable
Install the 8HP interface board
Connect the OBP ICP adapter
Short the CAN resistor on the OBP ICP adapter to the"CAN R JOIN" terminal
Connect the ACDP host
Power up the ACDP host
Open ACDP software
Please confirm the ACDP host is properly connected
Click "BMW">>"EGS">>"8HP ISN Clear (supports E chassis)">>"Clear ISN"
Confirm that the ACDP device is connected to the EGS module, and click "Continue"
Confirming that EGS supports clearing ISN and ISN not cleared, click "Continue"
Confirm the system programming information
Click continue to start programming the EGS module
The EGS module is being programmed...
ISN data is being cleared...
Clearing ISN data successfully
Click on the EGS status
Confirm that the ACDP device is connected to the EGS module
Confirm that the ISN has been cleared
Done!
For more details on the operation, please refer to the following video:
No comments:
Post a Comment